Spend more time shooting your pistol,and less time reloading your charges!
Quickly load your pistol's cylinder with this loading press. Accurately
control the seating pressure, even seat oversize balls with ease.
This Powder Inc. C & B Revolver Reloading Stand can be used with all
percussion Cap & Balls Pistols (Ruger Old Army, Colt Army, Navy and
Remington Revolvers).
Fully adjustable for most original and reproduction Cap & Ball Pistols.
Two cylinder pins, three sizes of jags are included. Two set screws are use to align
your Ruger Old Army, Colt Army,
and Navy revolvers, as well as Remington reproductions.
Video
Thanks to Rowdy Fulcher! Rowdy has produced a video demonstrating the Cap and Ball Loader.
Instructions
Setting up
The loader is supplied with two cylinder pins. The small pin is for the Ruger and Remington Revolvers.
The large pin is for the Colt Revolvers.
The loader is supplied with three loading jags:
40-45 cal jag - used with the Ruger Old Army & Colt Army
32-36 cal jag - used with the Navy Revolver amd pocket pistol jag
Adjustments
Adjust the cylinder plate to align the cylinder with the loading ram.
This plate adjusts with two cap screws.
Loosen the cap screws and, with the cylinder mounted on the cylinder pin (supplied),
align the cylinder with the loading ram.
Tighten the two set screws.
Loading
If you plan on loading a wad between the ball and the charge,
we find it better to compress the wad and powder charge and then seat the ball on top.
If no wad is to be used, simply seat the ball on the powder charge.
This cylinder loader will allow you to reduce your powder charge
and still get good seating pressure on your load.
Leaving an gap or air space in your black powder charge will
cause the powder to burn unevenly, probably reducing accuracy and
possibly damaging the gun.
Orders shipped UPS Ground to the United States.
International orders
Please call 1-877-833-1799 for information.
